Putting on Fox Oscillators in Navigation System (GPS)
GPS System consists of Antenna, LNA, SAW filter, GPS RF Front-End and GPS Module which includes Fox Crystal Oscillators, Fox RTC crystal having frequency 32.768 KHz, and an LDO (low drop out) regulator. Antenna: - It transfers the transmitter energy to signals in space making use of required distribution and efficiency. It also measures the direction accurately. Low Noise Amplifier (LNA):- It is really a special type of electronic amplifier which amplify the weak signal received via the Antenna and decrease the noise into the received signal and. It is often placed very close to antenna to minimize the losses is situated the coaxial cable feed line because the device is very loss at microwave frequencies. Surface Acoustic Wave Filter (SAW):- SAW filters received the amplified signal from Low Noise Amplifier and fed on the GPS RF Front-End. It is electromechanical devices in which electrical signals are converted to an analog wave in a system constructed of a piezoelectric crystal or ceramic. GPS RF Front-End:- RF front end is a generic term which is in a receiver that sits between the antenna and the intermediate frequency (IF) stage. GPS Module: - It includes Fox Crystal Oscillators, RTC crystal having frequency 32.768 KHz plus LDO (Low drop out) regulator. Few series of FOX are used as a TCXO in GPS application such as FOX923GP, FOX914 and FOX312BE series because of clipped sine output, 0.5 PPM stability, and 1.8 to a few.3 operating voltages. FOX series are used as a RTC crystal in GPS application such as FX255, FX145 and FX135 series because of long term stability and frequency of 32.768 KHz. The Fox products which are used in GPS application are RoHS-Compliant product.